ANSI/SMPTE 164-1993 电影胶片(8mmS型).磁性录音.位置、尺寸和重放速度
作者:标准资料网 时间:2024-05-20 15:25:44 浏览:9228
来源:标准资料网
【英文标准名称】:Motion-PictureFilm(8mmTypeS)-MagneticAudioRecord-Positions,Dimensions,andReproducingSpeed
【原文标准名称】:电影胶片(8mmS型).磁性录音.位置、尺寸和重放速度
【标准号】:ANSI/SMPTE164-1993
【标准状态】:作废
【国别】:美国
【发布日期】:1993
【实施或试行日期】:
【发布单位】:美国国家标准学会(ANSI)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:影片;工艺学;电影胶片
【英文主题词】:motion-picturefilm;technology;films
【摘要】:
【中国标准分类号】:G81
【国际标准分类号】:37_060_20
【页数】:
【正文语种】:英语
Product Code:SAE ARP868
Title:Method-Pressure Drop Tests for Fuel System Components
Issuing Committee:Ae-5 Aerospace Fuel, Oil And Oxidizer Systems Committee
Scope:This document provides recommended methods and describes associated equipment and test setups to assist in understanding and conducting pressure drop tets on fuel system components. Backgroundn information and suggestions are provided as means of improving accuracy and repeatability of test results. Although written specifically for fuel system components, the methods, equipment and suggestions presented herein apply equally to pressure drop tests of other liquid-handling devices.Product Code:SAE USCAR34
Title:Specification for Testing Automotive Lamp Assemblies
Issuing Committee:
Scope:The procedures contained in this specification cover the laboratory testing of Exterior Lamps for use in automotive road illumination. The following tests are intended to be run under the following conditions.This document shall be applied to systems that meet the requirements for design, performance and validation established by government standards.If other manufacture’s components are intended to be approved for use in the lamp assembly, then those possible combinations of components shall be considered a new lamp assembly and shall also be tested.The procedures contained in this specification cover the laboratory testing of Exterior Lamps for use in automotive road illumination. The following tests are intended to be run under the following conditions.This document shall be applied to systems that meet the requirements for design, performance and validation established by government standards.If other manufacture’s components are intended to be approved for use in the lamp assembly, then those possible combinations of components shall be considered a new lamp assembly and shall also be tested.
